China Huawei c2800 Done With C2808 File
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.54
Selected Resurrector: [QSC60XX L20 D08 NOR V1.0.0.0]

Connecting to the dead body...OK
Detected dead body ID: 0x220B10E1 - CORRECT!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Settings Code: 0x34010000000000000000000000800000

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0020/0x8848 (8MB)

Writting FLASH1 memory from 0x000000000000 to 0x0000007FFFFF
Completed in 00:03:30.735 (Average Transfer Rate: 38.87 kB/s)

Lumia 620 Successful Resurrection

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.54
Selected Resurrector: [Nokia Lumia 620 V1.0.5040.60717]

Connecting to the dead body...OK
Detected dead body ID: 0x207D00E1 - IGNORED!
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0011/0x0100 (008G92, 0x0001D2000000 Bytes = 7.28 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0011/0x0100 (008G92, 0x000000400000 Bytes = 4.00 MB)

No Resurrection Data is available for the eMMC Chip with Capacity = 7.28GB
WARNING!!! Using Resurrection Data for the eMMC Chip with Capacity = 7,23GB

Flashing the dead body...OK
Resurrection complete!

br,

[10/19/2013 4:16:59 PM] Open serial port...OK
[10/19/2013 4:16:59 PM] Connecting to the RIFF Box...OK
[10/19/2013 4:16:59 PM] Firmware Version: 1.37, JTAG Manager Version: 1.54
[10/19/2013 4:16:59 PM] Selected Resurrector: [Pantech A650S V1.0.4968.19269]
[10/19/2013 4:16:59 PM] Restarting target (nRST Low then High)...OK
[10/19/2013 4:16:59 PM]
[10/19/2013 4:16:59 PM] Connecting to the dead body...OK
[10/19/2013 4:16:59 PM] Detected dead body ID: 0x202400E1 - IGNORED!
[10/19/2013 4:16:59 PM] Set I/O Voltage reads as 2.59V, TCK Frequency is 8 MHz
[10/19/2013 4:16:59 PM] Settings Code: 0x27010B00000000000000000040000000
[10/19/2013 4:16:59 PM]
[10/19/2013 4:16:59 PM] Resurrection sequence started.
[10/19/2013 4:16:59 PM] Establish communication with the phone...OK
[10/19/2013 4:16:59 PM] Initializing internal hardware configuration...OK
[10/19/2013 4:16:59 PM] Uploading resurrector data into memory...OK
[10/19/2013 4:16:59 PM] Starting communication with resurrector...OK
[10/19/2013 4:16:59 PM]
[10/19/2013 4:16:59 PM] Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x55B3 (1024MB)
[10/19/2013 4:16:59 PM]
[10/19/2013 4:16:59 PM] Looking for the RIFF BOX DCCLoader USB Interface Port...FAILED
[10/19/2013 4:16:59 PM] The DCCLoader USB Interface is not found. Communication continues over the DCC Interface
[10/19/2013 4:16:59 PM]
[10/19/2013 4:16:59 PM] Writting FLASH1 memory from 0x000000000000 to 0x00003FFFFFFF
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x24) at 0x00000A7A0000. Attempting to Repeat.
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x24) at 0x00000A7A0000 is Ignored.
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x25) at 0x00000A7B0000 is Ignored.
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x24) at 0x000012480000 is Ignored.
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x25) at 0x000012490000 is Ignored.
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x24) at 0x00002F200000 is Ignored.
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x25) at 0x00002F210000 is Ignored.
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x24) at 0x0000313A0000 is Ignored.
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x25) at 0x0000313B0000 is Ignored.
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x24) at 0x00003A9C0000 is Ignored.
[10/19/2013 4:16:59 PM] WARNING: Programming Error (0x25) at 0x00003A9D0000 is Ignored.
[10/19/2013 4:16:59 PM] Completed in 01:16:08.969 (Average Transfer Rate: 236.67 kB/s)
[10/19/2013 4:16:59 PM] [FINISH OPERATION_ID = DCC_WRITE_MEMORY]

[10/21/2013 12:13:00 AM] [START OPERATION_ID = JTAG_ANALIZE]
[10/21/2013 12:13:00 AM] Open serial port...OK
[10/21/2013 12:13:00 AM] Connecting to the RIFF Box...OK
[10/21/2013 12:13:00 AM] Firmware Version: 1.37, JTAG Manager Version: 1.54
[10/21/2013 12:13:00 AM] Selected Resurrector: [HTC Desire V1.00]
[10/21/2013 12:13:00 AM]
[10/21/2013 12:13:00 AM] Connecting to the target...OK
[10/21/2013 12:13:00 AM] Set I/O Voltage reads as 3.00V, TCK Frequency is RTCK
[10/21/2013 12:13:00 AM]
[10/21/2013 12:13:00 AM] Following devices are found on the JTAG chain:
[10/21/2013 12:13:00 AM] Device on TAP #0: ID = 0x202400E1, IR Length = 0x04 bits
[10/21/2013 12:13:00 AM] Total IR length: 0x0004 bits
[10/21/2013 12:13:00 AM]
[10/21/2013 12:13:00 AM] Analizing IDCODE(s) of the JTAG scan chain:
[10/21/2013 12:13:00 AM] 1. 0x202400E1: Qualcomm QCS8250, H/W Rev. #2
[10/21/2013 12:13:00 AM] [FINISH OPERATION_ID = JTAG_ANALIZE]



[10/21/2013 12:13:01 AM] [START OPERATION_ID = GET_DEVICE_ID]
[10/21/2013 12:13:02 AM] Open serial port...OK
[10/21/2013 12:13:02 AM] Connecting to the RIFF Box...OK
[10/21/2013 12:13:02 AM] Firmware Version: 1.37, JTAG Manager Version: 1.54
[10/21/2013 12:13:02 AM] Selected Resurrector: [HTC Desire V1.00]
[10/21/2013 12:13:02 AM]
[10/21/2013 12:13:02 AM] Connecting to the dead body...OK
[10/21/2013 12:13:02 AM] Set I/O Voltage reads as 2.99V, TCK Frequency is RTCK
[10/21/2013 12:13:02 AM]
[10/21/2013 12:13:02 AM] Detected dead body ID: 0x202400E1
[10/21/2013 12:13:02 AM] [FINISH OPERATION_ID = GET_DEVICE_ID]



[10/21/2013 12:13:06 AM] [START OPERATION_ID = RESURRECT]
[10/21/2013 12:13:54 AM] Open serial port...OK
[10/21/2013 12:13:54 AM] Connecting to the RIFF Box...OK
[10/21/2013 12:13:54 AM] Firmware Version: 1.37, JTAG Manager Version: 1.54
[10/21/2013 12:13:54 AM] Selected Resurrector: [HTC Desire V1.00]
[10/21/2013 12:13:54 AM]
[10/21/2013 12:13:54 AM] Connecting to the dead body...OK
[10/21/2013 12:13:54 AM] Detected dead body ID: 0x202400E1 - CORRECT!
[10/21/2013 12:13:54 AM] Set I/O Voltage reads as 2.99V, TCK Frequency is RTCK
[10/21/2013 12:13:54 AM] Adaptive Clocking RTCK Sampling is: [Sample at 4 MHz]
[10/21/2013 12:13:54 AM]
[10/21/2013 12:13:54 AM] Resurrection sequence started.
[10/21/2013 12:13:54 AM] Establish communication with the phone...OK
[10/21/2013 12:13:54 AM] Initializing internal hardware configuration...OK
[10/21/2013 12:13:54 AM] Uploading resurrector data into memory...OK
[10/21/2013 12:13:54 AM] Starting communication with resurrector...OK
[10/21/2013 12:13:54 AM]
[10/21/2013 12:13:54 AM] Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x55BC (512MB)
[10/21/2013 12:13:54 AM] Selected Resurrection Data for the NAND Chip with Page size = 2KB
[10/21/2013 12:13:54 AM]
[10/21/2013 12:13:54 AM] Flashing the dead body...OK
[10/21/2013 12:13:54 AM] Resurrection complete!
[10/21/2013 12:13:54 AM] [FINISH OPERATION_ID = RESURRECT]



[10/21/2013 12:14:59 AM] [START OPERATION_ID = RESTART_TARGET]
[10/21/2013 12:14:59 AM] Open serial port...OK
[10/21/2013 12:14:59 AM] Connecting to the RIFF Box...OK
[10/21/2013 12:14:59 AM] Firmware Version: 1.37, JTAG Manager Version: 1.54
[10/21/2013 12:14:59 AM] Selected Resurrector: [HTC Desire V1.00]
[10/21/2013 12:14:59 AM]
[10/21/2013 12:14:59 AM] Restarting target (nRST Low then High)...OK
[10/21/2013 12:14:59 AM] [FINISH OPERATION_ID = RESTART_TARGET]


Phone go to hboot and flash done with stock RUU
Thanks Riff Team and Mr.Legija